please do let know what to do if want to use my old graupner/jr reciever 53MHZ with my fs 9ch TX TH001
nissim
]]>pliease do let know what to do if want to use my old graupner/jr reciver 53mhz with my fs9ch th0001 TX
NISSIM
]]>I just got my new transmitter FS 9ch module m001 and (im new in this busniess) BCS reciever who coms with the transmitter ruined need for new .
Please do let know if i can buy and use HKR8A instead
please do let know where I plug the new receiver ESC (terx 450 ornament)in new reciever
rgds
הצע תרגום טוב יותר
]]>Once I have the batteries soldered together they obviously no longer fit in the standard AA trickle charger. How can I charge them with my standard Thunder AC LIPO charger which has settings for NiMH? There is no balance plug on the new DIY pack – or is there a way to make one?
Thanks in advance.
]]>An excerpt from the top:
Following the DIY from rcmodelreviews.com, it now runs off of 2×3.7v 2400mah batteries. You need to solder a 8.2K ohm resistor to the board. The reason why you need to solder the resistor is to fool the alarm to not beep when the voltage is lowered. (Or you can just rip out the speaker 🙂 You have to build your own 7.4v battery pack. I soldered the male servo connector to the battery. I then made an adapter that is a female servo connector > 2S connector so I can plug it to the transmitter’s connector. I charge the battery with my Lipo charger at about 1.2A as a 2s/7.4v battery.
]]>Thanks in advance.
]]>