Where to buy: HobbyKing Mini Super Jet

I believe this is a clone of the Axon Firefox but almost half the price.   This is a very simple plane to build.  It has about 9 pieces of foam and can be built in a couple of hours with some foam safe glue.  The fuselage is built out of strips of EPP foam while the wings are depron foam.

It’s almost an exact clone of the Axon Firefox

Specifications
Length : 442mm (17.4in)
Wing Span: 420mm (16.5in)
Flying Weight: 55~63g (with battery)

Included in the box
C05 3700kv Brushless outrunner
7Amp ESC
GWS 4×2.5 prop

Things you need to buy
Your own TX & RX (I use my HK T6A)
100~350mah 1~2S 20C Lipo
2 x 2.5g servo
v-tail mixer (if your radio doesn’t do mixing)
foam safe CA glue

This plane only has 1 set of control surfaces.  They combine aileron and elevator, so elevons.  In order to properly set it up, you need a v-tail mixer or a radio that does mixing.  I used my HobbyKing 2.4ghz T6A transmitter and receiver and it supports mixing so you don’t need a v-tail mixer.  Here is the setup file for it if you are using KISS’s Turborix programmer.

If you have other radios then you need to setup the 2 mixes on your own.  Here are the mixes.  I was able to do mixes on my Spektrum DX6i and Art Tech radios.

MIX 1
Master: CH1
Slave: CH2
Rate: 100%

MIX 1
Master: CH2
Slave: CH1
Rate: -100%

You may have to reverse some CH1 or CH2 to get the elevon to work right.

Videos coming soon …